60 to 52mm Gauge Adapter 3D print model

License: Royalty Free

author:

Kaeroth3D

All content related to this 3D asset—including renders, descriptions, and metadata — is credited to its original author, «Kaeroth3D». CGhub does not claim copyright ownership over the content used.

A simple adapter for installing 52 mm gauges in 60 mm pods.

This particular adapter was designed for use in a triple gauge pod that goes on top of the center console. It has a slight tilt of 10° so the gauge can be installed facing the driver's seat instead of the rear seats.

Consider this before printing:

You may need to glue the adapter to the pod.
Use ABS or ASA to print (or better) Keep in mind that it will need to withstand high temperatures and sunlight.
REMEMBER: if you print with ASA you need good ventilation. DON'T BREATHE THE GASES!
Enable supports (only necessary for the outer ring).

That's all, good luck with your prints!