Adapter Opel Astra H Rear Speakers 130mm 3D print model

$4.99

License: Royalty Free

author:

ProMelt

All content related to this 3D asset—including renders, descriptions, and metadata — is credited to its original author, «ProMelt». CGhub does not claim copyright ownership over the content used.

I made this adapter because my original speakers didn't work, I replace them but needed a universal adapter for my Opel Astra H from 2006, so this model was the solution.This model fits perfectly in my car, you can buy any speaker with a 130mm diameter, and then you just need to buy an adapter cable from the speaker to your car.

Print Tips*

Layer Height: 0.2mm;
Infill: 20%;
Supports: No;
Print Speed: 50 mm/s;
Material: PLA or PETG.
These are my recommendations for the same result then you can see in the pictures, but you can change the settings to fit your needs.

Good Luck,ProMelt.