3D Bentley Flying Spur model made with Blender 2.9. Textures packed to blend file. If you download other formats you may need to download textures too.Thanks
The Bentley Flying Spur (formerly the Bentley Continental Flying Spur) is a luxury saloon produced by Bentley Motors Limited since 2005 and was released in 2006. It is the four-door variant of the Bentley Continental GT coupé.
The car is manufactured at Bentley's factory in Crewe, England. Briefly, due to a lack of capacity at the Crewe factory upon the car's introduction, some Flying Spurs destined for markets other than the United States and the United Kingdom were built at Volkswagen's Transparent Factory in Dresden, Germany. This arrangement ended in 2006 when all assembly work reverted to CreweThe third-generation Flying Spur was unveiled in June 2019. The car has been completely overhauled and is built on a brand-new platform, resembling the current Continental GT. The front receives a new grille with vertical slats akin to that of a Rolls-Royce, while the rear features new taillights that incorporate a B motif. The hood ornament is now illuminated at night, electrically deployable, and capable of meeting pedestrian impact requirements. Rear-wheel steering is new and is accompanied by air springs with 60 percent more volume than its predecessor. The all-wheel drive system is also new and uses an electronically controlled clutch pack. The interior boasts a rotating 12.3-inch (31.2-cm) display and an all-new Touch Screen remote that allows rear occupants to control several systems. Compared to the second generation model, the new Flying Spur gets close to 130 mm additional wheelbase. It accelerates from 0-60 mph in 3.7 seconds and reaches a maximum speed of 207 mph(333 km/h).
The Flying Spur will become the only Bentley sedan model, as production of the Mulsanne ends in the second quarter of 2020 without a direct successor.
BLEND (Blender, filesize: 60.9 MB), BLEND (Blender, filesize: 60.9 MB), OBJ (OBJ, filesize: 69 MB), FBX (Autodesk FBX, filesize: 34.6 MB), GLTF (glTF, filesize: 19.6 MB), ABC (Alembic, filesize: 31.1 MB), DAE (Collada, filesize: 74.6 MB), STL (Stereolithography, filesize: 44.5 MB), MS3D (MilkShape 3D , filesize: 61.9 MB), USDZ (USDZ, filesize: 31.1 MB), PLY (Ply, filesize: 27.4 MB)
