Drip Emitter V2 -No wings - 3Dponics Emitters and Plugs Free 3D print model

free

License: Editorial No Ai Html

author:

3dponics

All content related to this 3D asset—including renders, descriptions, and metadata — is credited to its original author, «3dponics». CGhub does not claim copyright ownership over the content used.

Version 2 of the Drip Emitter is used to drain excess water from pots that have a hole at the bottom. It fits snuggly inside the hole--all you have to do is snap it into place. For an extra secure seal, you can use silicone around the edges. You can then connect a long piece of tubing to the end of the Emitter and direct it into a large container or reservoir, which will collect the excess water. The thicker nozzle allows for a better, tighter fit with the flexible tubing. Know how to make this part better? Have ideas for new parts? Visit our website (https://www.3dponics.com) and join our Google+ community (https://plus.google.com/u/0/communities/111638904033818784260) to take 3Dponics to the next level!

Want to know how much it would cost to print this part? Visit https://www.3Dprintler.com and compare prices from today's top 3D-printing services.

3D Model details

cgtrader Platform
Animated
Rigged
Ready for 3D Printing
VR / AR / Low-poly
PBR
Textures
Materials
UV Mapping
Unwrapped UVs: Unknown
Geometry: Unknown
Polygons: 0
Vertices: 0

Tags

3dponics Hydroponics Garden Indoor Aquaculture Flower Vegetables Plantation Hobby Interest Agriculture Decor Diy Hole Plug Parts challenge House Outdoor Home Living

Similar models