Sci Fi Armour Square Top plates 3D print model

$6.62

License: Royalty Free

author:

greymanwaylander

All content related to this 3D asset—including renders, descriptions, and metadata — is credited to its original author, «greymanwaylander». CGhub does not claim copyright ownership over the content used.

STL files only.

Theses are the Top plates only and have a square pattern finish. It contains the Top plates that are compatible with the Back plates. You can pick additional sets of front plates to mix and match.

• Within the total range of Top plates there are the following Patterns. Six sets of armours in total. 1 x Smooth set.1 x Square pattern set.1 x Hexagonal pattern set.1 x Diamond Pattern set.1x Circle pattern set.1x Zigg Zagg set.Plus, I’ve added a set of Back plates so you can select just those you want to use.

• All these sets mix and match as you desire, to achieve the style you want. So, you could select the full set of smooth armour, then later you can just pick up one of the other shapes to add to your sets.

• These use m5 bolts / screws in the chest and M3 in the abb sections.

• The straps cut-outs are made for 25mm / 1-inch-wide Webbing.

• These will need mirroring and splitting from each other. I tried to upload separate files but was unable too.

• I’ve printed out a few pieces from across the range to show how they will look. As an example, on the printed and painted section in my photo you'll see a set that’s had the webbing straps added. Normally these would connect the left- and right-hand sides.

• I also painted up in different colours to suggest some different looks. Such as a silver and gold set, and a set that looks similar to the ODST colours from Halo.

Drop me a line with any questions you may have.