Skoda Octavia mk1 Cup and Beverage holder 3D print model

Publication date: 2021-09-03

Skoda Octavia mk1 Cup and Beverage holder 3D print model

License: Royalty Free

author:

josefson92

All content related to this 3D asset—including renders, descriptions, and metadata — is credited to its original author, «josefson92». CGhub does not claim copyright ownership over the content used.

REUPLOAD 2 (22.12.2021) versions of the cup holder

additional versions of the drink holder added
- V2.0 = original version of the holder
- V2.5 = new version (parts holder and top_angle are printed as one part, after printing the top_angle part is bent and glued).

The V3.0 and V3.5 versions are the same as the V2.0 and 2.5 versions, only I removed the smaller hole for the straws from the holder model.

REUPLOAD (older) version of the drink holder

fixed geometry issues
holder divided into 2 parts, when glued together with adhesive it creates a neat compact surface

Cup holder for the first generation Skoda Octavia. Installation with high quality double-sided adhesive tape. Fits exactly in place and follows the centre tunnel plastic.

WARNING: when fitting it may not fit exactly, the screws located under the rear ashtray must be loosened, the plastic handbrake cover must be fitted to the cup holder.

This is the second version of the holder, with a side bevel for easy operation of the handbrake lever.

The drink holder needs to be printed with 2 pieces of 1.5mm thick bottom, which are included in the object files. These prints need to be glued in place with adhesive to create a smooth compact bottom.

The holder is printed with the top side on the heated pad of your 3D printer.

It is necessary to use high quality filament PETG, ABS, ASA, Nylon, with a minimum of 5 perimeters and a minimum of 20% fill. The print must be resistant to high temperatures inside the car and their rapid fluctuations. Avoid the use of PLA.