SUTURUS PATTERN DOMINATOR FLAMER CANNON 3D print model

$4.99

License: Custom No Ai

author:

johnbearross

All content related to this 3D asset—including renders, descriptions, and metadata — is credited to its original author, «johnbearross». CGhub does not claim copyright ownership over the content used.

A modular flamethrower cannon that bathes the battlefield in armor-melting hellfire.

While you can use this cannon on your already-magnetized Dominant Knights, everything from the shoulder to the weapon muzzle is provided.

-Shoulder (5 different angles)-Upper Arm (ball and socket for Main Weapon Body)-Side Armor (Two styles, and a blank for custom adaptations)-Main Weapon Bodies (Two styles)-Main Weapon Muzzles (Four styles)-Optional Armor Cowls (Front and rear)

This weapon is a little longer, but it is also sleeker, which I think balances it out.

Some hand-fitting and patience may be required for gluing the side armor to the upper arm. Profanity sometimes helps. ;)

I recommend 12mm magnets (12 x 2mm or 12 x 3mm) at the elbow sockets. If you are doing multiple weapons, make sure your poles are compatible.

If you don't glue the muzzles to the main weapon bodies, I recommend a 12mm magnet in the body and a stack of small washers in the muzzle's receptor. I used a pair of #8 washers (9.5mm outer diameter) with a little bit of room to spare. Metric folks can use a 5mm washer, which should have a 10mm outer diameter.

Enjoy!

Best,JBR

3D PRINTING SETTINGSNo pre-supported versions, since every machine and material are different.

I used Chitubox autosupports at 70% density, and didn't lose a single part. The barrels are pretty self-supporting. Orient everything vertically for best results. It may take more time, but boosts quality.