The J – 3D Printable Precision Powder Dispenser (0.1 g Dose / 2 g Capacity / Air-Tight Cap)
DescriptionThe J is a compact, 3D-printable powder dispenser engineered for precise, clean handling of finely ground herbal or aromatic powders.Its ergonomic design, air-tight cap, and reliable dosing system make it a practical and stylish everyday tool for controlled micro-dispensing.
Contents
- Main Body: Contains the internal 2 g powder chamber.
- Centre Mechanism (Sliding Body with Reservoir for 0.1 g, externally labelled with arrow): Controls loading and dispensing positions.
- Air-Tight Top Cap: Protects contents from moisture and spillage.
DimensionsApprox. 51 mm (height) × 23 mm (diameter) – pocket-size and travel-friendly.
Usage Instruction ManualLoading Powder: 1 - Twist or slide the centre mechanism to the ▲ (arrow up) position. 2 - Remove the air-tight cap. 3 - Pour finely ground powder into the main chamber (max 2 g). 4 - Replace the cap and ensure it is securely sealed.Dispensing Powder: 1 - Rotate the centre mechanism to the ▼ (arrow down) position. 2 - In this position, the internal air-intake geometry releases approximately 0.1 g per dose. 3 - Return the mechanism to the ▲ position to reload for the next dispense.
Cleaning & Maintenance: 1- Empty any remaining powder before cleaning. 2- Use a dry brush or compressed air for light cleaning. 3 - For wet cleaning, rinse with warm water only; avoid solvents. 4 - Allow all parts to dry completely before reassembly.
(Promotional Photos Generated by AI)Keywords: bullet, powder dispenser, micro doser, precision dispenser, functional print, airtight container, pocket dispenser, portable dispenser, herbal accessory, compact design, ergonomic tool, everyday carry, DIY gadget, reusable tool, eco design
3D printing settingsRecommended Print Settings Body:Setting / RecommendedLayer height 0.15 – 0.20 mmMaterial PLA (The 3D-Design was optimised for PLA printing)Infill 20 %Supports Not required (if correctly oriented)
Recommended Print Settings Air-Tight Cap:Setting / RecommendedLayer height 0.15 – 0.20 mmMaterial PLA (The 3D-Design was optimised for PLA printing)Infill 50 %Supports Not required (if correctly oriented)
STL (Stereolithography, filesize: 2.51 MB), PDF (PDF, filesize: 3.55 KB)
