THE N-LANES DIECAST CAR STARTER BOX 3D print model

License: Royalty Free

author:

Custom-3D-Modeling-Services

All content related to this 3D asset—including renders, descriptions, and metadata — is credited to its original author, «Custom-3D-Modeling-Services». CGhub does not claim copyright ownership over the content used.

THE N-LANES DIECAST CAR STARTER BOX can be used as a starter for a multi lane diecast car race track. Just print as many boxes as you like and connect them with the connector piece. I have tested 4 Lanes so far which works quite nicely.

Print settings:

track: 10% Infill. print upright with raft. no supports

lid: print outside downwards

thestick: no special settings

starter: print on the side with 20% infill supports from the bed

lever: print upright on the side with 20% infill and supports

box: print upright. thin walls shouldnt be too worried about infill. might aswell use 100%

knob.stl: no special settings. wider end to the bed...

For assembly I used four M4 with M4 inserts to fix the track and close the box.

Also four M4 screws and nuts to connect the boxes.

1 short and one long connector plus 8 washers per connected 2 boxes.

Enjoy,...