With two zip tie holes provided, any size of flashlight can be fitted.Use 5 mm zip ties.
You can use any M2 screw of sufficient length to secure the ring.Use a thin rubber sheet or double-sided tape between the bar and the ring to prevent slipping.
Printing Notes:
- No supports required except screw holes.
- Print with 2 outline perimeters and 100% infill.
- 0.1 to 0.2 mm layer height should be good.
Features:
- Curved zip tie paths prevent stress-whitening when tightened.
- Curved mounting surface aligns the flashlight straight.
STL (Stereolithography, filesize: 263 KB), OBJ (OBJ, filesize: 110 Bytes), FBX (Autodesk FBX, filesize: 835 KB)