Buy LArendsian Whirlwind - Sprite Maker - Concept 3D model

L'Arendsian Whirlwind - 360 Ionwind Wingloop Concept Sprite Maker.This device is for photographers that love to photograph and study sprites. this device can generate and create sprites on demand using only 24 vd Graaff generators. 8x4 stacked lithium-ion battery packs, 16 ultra capacitors, a tesla super coil, and some wiring ducts. this apparatus is the photographers dream device, no more guesswork, no more waiting for ours in the rain during storms, you can now know where they are or will be in the sky, every single time you want, study fresh new sprites for years to come.

the device creates a super high voltage, on top and central of the device, a spark gap between the ultra smooth hull surface ensures we create an ionic wind. the wind is pulled straight down along the entire hull, until it meets a hard angle below the craft, too large for it to want to make and be the shortest route, we strip the full speed ions loose from the hull but back onto the negative ion collecting aluminum ion collector ring beneath the craft, and back into the electrical system for re usage in the ion-loop. [External - Internal - Ad inf.].

the super capacitors allow us to use the gigantic battery pack stacks, and release a lot of charge near instantly, as needed, to create the ion wind loop around the hull, all over the outward top hull, downward, back into the craft able to hoover by creating its own wind on demand. we can use the massive amount of vd Graaff generators to also select a direction, by spinning them faster or slower on one side, we create more or less new [positive] charge on a particular side of the craft. the same principle can be used to draw a ion wind from the nose of the craft to the aft of the craft, to force it back or forward when in the air, pulling the ion wind from front to back, over and under the entire craft, in to a certain chosen direction.

the tesla coil can also store a gigantic amount of electrons, that come out of the capacitors, pressures them back upward, until they are again on the highest point of the craft, where they get released once more, onto the hull, finishing the ion wind loop. the spark gap has small needles, making the pressure too big, and the electrons then must make the jump there, at the highest pressure tip, then seeking equilibrium along all of the hulls ultra smooth surface. a little central top fan helps the ions move outward by an assisting force, making use of the Coanda effect, but now for ion winds instead of normal winds.

(could cut the disc shape in half for printing twice as fast on two machines, or even cut in quarters to divive the printing load over 4 machines).

thank you for reading, thank you for your support, every like helps me out a little.